• The Pump Controller 701P is supplied with a hydrostatic pressure transmitter with measuring ranges of 3, 10 or 30 m.
• Pump Controller 701P is calibrated via the front panel. The setting values are read on a voltmeter connected to the test sockets on the front, where 0 – 3 V corresponds to 0 – 3 m / 0 – 30 m, and 0 – 1 V corresponds to 0 – 10 m.
• Pressure transmitters 7060 and 3400 are made of polypropylene and suited for measurement in waste water and sludge.
• Pressure transmitters 7070 and 1400 are of stainless steel with a small outer diameter and are used for clean liquids, for example in water drillings.

Amplifier 701P for DIN-rail

• Measuring range: 4-20 mA (0 – 0,3 m / 0 – 1 m / 0 – 3 m / 0 – 10 m / 0 – 30 m / 0 – 100 m / 0 – 300 m)
• Supply: 220 – 240 V AC or 110 – 130 V AC
• Temperature: – 20 … + 60 °C
• Input signal: From pressure transmitter (4-20 mA)
• Accuracy: ± 1.0 %
• Outputs: 2 relays with voltage free change-over switch. 250 V, 4 A resistive load (inductive 100 VA).
• Operation: From front panel
• Dimensions: 86 x 70 x 60 mm (h x w x d)
• Enclosure: IP 22

Pressure Transmitter 7060 and 7070

• Measuring ranges: 0 – 3 m with pressure transmitter 7060 – 1413 or 7070 – 1413, 0 – 10 m with pressure transmitter 7060 – 1423 or 7070 – 1423, 0 – 30 m with pressure transmitter 7060 – 1433 or 7070 – 1433
• Signal: 2-wire, 4-20 mA
• Accuracy: ± 0.5 % of measuring range
• Temperature: – 10 … + 60 °C
• Dimensions: Type 7060: Dia. 60 x 140 mm, Type 7070: Dia. 22 x 150 mm
• Material: Type 7060: House in PP, diaphragm in acid proof steel (AISI 316L), Type 7070: House and diaphragm in acid proof steel (AISI 316L )
• Cable: 2 x 0,5 mm2, Length = 12 m, (7060 / 7070 – 1433: 35 m), can be extended.
• Mounting: Suspended on bracket
• Enclosure: IP 68, water proof, max. 3 bar.